Can you believe that a new aftermarket not only enhances your car’s capabilities but also takes your driving experience up a level? There is no exaggeration because an ideal car stereo do plays an important role in your car. If you are not so satisfied with your factory radio, then you can try to upgrade it with a new aftermarket stereo. And an ultimate instruction is necessary for your installation. The following is the step-by-step installation instruction from Seicane for a 2005 2006 Chevrolet Corvette gps bluetooth Stereo. If you also own such a vehicle type, you might refer to this instruction.
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2005 2006 Chevrolet Corvette car stereo installation instruction
1. Move the shift lever down to the lowest position. So you can have enough room to get access to the radio.
2. Use a pry tool to pop off the radio panel.
3. Remove connectors at the back of the radio panel and set the panel aside.
4. There are four screws holding the radio. Use a screwdriver to remove these four screws.
5. Pull out the original radio.
6. Disconnect the connectors and cables at the back of the radio.
7. Check all the accessories for the new Seicane car stereo.
8. Connect the harnesses to the back of the new Seicane car stereo.
9. Connect the Seicane car stereo to your original car radio’s plugs.
10. Turn on the new Seicane stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. If the new Seicane car stereo works well, put it into the dash.
12. Put everything into their original place, and all the installation is done.
That’s all about the detailed steps to install a new stereo for your 2005 2006 Chevrolet Corvette. If you encounter any difficulties in understanding these steps, please feel free to consult a professional technician. Any way, first of all, you have to purchase an ideal stereo for ensuring a successful car stereo installation process. If you have no ideas, I’d like to share a remarkable 2005 2006 Chevrolet Corvette gps bluetooth Stereo from Seicane with you. For more details, please click:
This modern car stereo is specific for Chevrolet Corvette which is manufactured in 2005 and 2006. This stereo is equipped with the stable Android 5.1.1 operation system and a high quality Quad-core CPU, so it can offer users the best services because of its higher capabilities and configurations.
Even you are not good at identifying directions, you won’t get lost any longer since this stereo provides you with the accurate GPS satellite location, turn-by-turn navigation, voice prompts and cursor hints.
And by simply pairing with your Bluetooth-enabled mobile phone, this stereo enables you to dial, receive, reject and mute hands-free phone calls as well as listen to the music streaming from your Bluetooth-enabled devices to keep your journey safe, convenient and joyful. Thanks for reading and have a nice day!