I’d like to show you a picture at the beginning of this article:new unit after replacement,gps dvd autoradio aftermarket sat nav system of 2011 2012 Toyota Avalon.
This unit matches your car if it is one of 2011 2012 Toyota Avalon.To see the space after head unit removal is whether right for new unit is the only way to figure this question.After you are sure that this head unit is suitable for your car and decide to install a new one by yourself,then you are right to read this essay which will show you installation guide for 2011 2012 Toyota Avalon gps radio aftermarket sat nav system.
It also doesn’t matter if it seems to be improper for your car,because there are some places for stereo upgrade are common,it means that you can also learn a lot from the following description,and probably you can provide some advises to your friend.
Installing an aftermarket car stereo can be a self-done thing doesn’t mean that you can do it without taking care of anything.There are some notes for you before you begin any work.
Precautions before installation:
1.Please do not stop your car very suddenly,it may cause injury to driver and passengers
2.Before opening the hole from face plate in the dashboard panel,make sure that the rear space is enough.Be careful,do not damage the fuel cable,brake cable,electrical components,power lines or cable communications
3.When use the screws,please ensure that they are not contact with any electrification down-lead.Vibration may have damaged wire or insulation skin and lead to a short circuit or other damage to the vehicle
2011 2012 Toyota Avalon car stereo removal and installation:
1.Original CD radio
2.Get the gear shift panel out
3.Get screws out as the picture show
4.Take the lid of the surface out with a soft lever
5.Take two screws out as the image show
6.Remove factory autoradio
7.This is removed factory car radio looks like
Head unit removal is finished here,and next work is Toyota Avalon gps installation.Actually it can be easier if you can complete the cable connection successfully.
Please be very careful when you are making connections on cables,for you should make sure that you have connected all wirings correctly.I recommend you to check it again if you are not very sure about it to avoid once stereo removal again.Then you can install the new unit into the space.
Turn on it and see whether the touch screen can work,then install other parts that were removed before to their original places.This is the whole installation process.
If you still have any doubts or problems that troubles you,you can visit some websites to solve them,such as http://www.seicane.com/8-inch-autoradio-dvd-car-audio-system-for-2011-2012-toyota-avalon-with-3d-gps-bluetooth-radio-rds-3g-wifi-tv-tuner-mp3-mp5-ipod-aux-hd-1080p-video-backup-camera-c270 ,
which can directly solve problems on this unit andhttp://www.seicane.com,where there are a lot of stereo there and you can have a general idea about car dvd.