Head unit after installation,GPS radio audio with navigation system of 2012 2013 Chevrolet Colorado.
When you have a look at this picture,I guess you may be curious about this new stereo for it’s a little different from your factory one on its outward and features.New unit’s screen is a touch screen which can be operated by a special touch screen pen.And it has increased some convenient and entertaining functions,if you want to know it more detail,you can visit some related websites,for example:http://www.seicane.com/oem-in-dash-radio-replacement-mp5-player-for-renault-duster-built-in-gps-pop-dvd-bluetooth-support-anti-shock-2-channel-aux-3g-wifi-c157.
It should be more convenient if your Chevrolet Colorado has upgraded car audio.So many drivers would like to install one but have no idea about how to install 2012 2013 Chevrolet Colorado radio audio with navigation touch screen.Don’t worry,it’s not hard to behave and also doesn’t need much professional skills,it just need you to be patient to know its operation and careful to do it.
Next I will show you detailed installation steps for Chevrolet Colorado radio,please be patient to read it and hope you will benefit a lot.
2012 2013 Chevrolet Colorado original radio removal and new radio installation:
1.Use a pry tool,softly pry the upper vent housing panel from the dash
2.Pry the edges of the panel arround it,after it is released remove it
3.Take 2 screws down from the storage pocket,pull off storage
4.Take 4 screws down from the control panel
5.Pull panel out,be patient and the clips will release let panel hang to side though the panel was very tough to remove
6.Take 2 screws down from the radio control panel,unplug the radio control panel
7.This is a really strange blue clip,before removing the real connector you must remove the blue clip completely ,and remove the other clip
8.Take 2 screws down from the radio chassis,and 2 screws near the top of the stereo to release the screen
9.Pulling screen out and remove it,remove behind clip
10.Take 2 more screws on radio down
11.Remove original stereo and cables behind it
You see,removal affairs has been finished,the following thing is to install a new stereo for your beloved car,and this following part is actually easier than removing steps.
After you have carefully read up installation instructions,make corresponding cables connection which you should try to make sure it precise.Please pay more attention on this because it’s very important to your installation.After that sort some disordered antennas and install new unit gently into the right space.
Turn on your radio and have a specific check for your installed head unit to see whether it can work properly.If the answer is yes,then continue actions including screwing screws tight to original places and reinstalling storage and trim panel to make everything back.You will enjoy very good time after you have finished whole procedure and drive a car with such a multimedia dash dvd with GPS bluetooth touch screen.