Most of you should be the owners of Ssangyong Actyon from 2006 to 2013 and have the desire to upgrade your car audio systems.Since some reasons you haven’t achieved
it maybe because you are too busy or you have no idea what to do with it.
If you are really busy and can’t spare time to do it,you can contact with the dealer who works for it and
let them to help you to install Ssangyong Actyon navigation system in your car.
In this process,there should be not only one radio that is suitable,so when someone is recommend you
one of it,you’d better look at more ones and make a comparison to choose a favor and better one.
And there are also a lot of people that want to do it himself,then you need to know detailed installation
steps for 2006-2013 Ssangyong Actyon navigation GPS dvd support 1080P AV in/out,you can take it as reference for your upgrade work.
Here is the picture for car head unit after installation,dvd gps navigation system of 2006-2013
This is a unit which is specially for Ssangyong cars,we know its general appearance from this picture.If you look very closely you can
find that this audio is a little different from other ones.You will see corresponding description about
it at latter section.And now we will get to know how to do this can self-done work.
2006-2010 Ssangyong Actyon original stereo removal and nav system installation:
Before you get to know it,I need to state that the following operations is not exactly for for Ssangyong
Actyon head unit removal and aftermarket sat nav installation,but usual solutions for removing a car stereo,which can benefit you
having a better understanding about installing new unit into your car.
1.Use a lever to pry downer small trim panel and remove it,then same to right side one
2.Make four removal tools inserted into four holes after surface panels are removed
3.Pull out factory stereo by pulling out these four tools
4.Disconnect cables behind the unit
5.Pry off higher small trim panels,then remove them,like step one
6.insert four removal tools into four higher holes
7.hold them and pull upper radio out
8.Make connectors behind it unconnected
If you think that you are not very familiar with that new unit,then you can seek for information
from web pages,for example:http://www.seicane.com/double-din-in-dash-gps-stereo-upgrade-
Now factory CD player is taken out and next job for you is to install new unit into it.Firstly,you
should read installation guide carefully which is within your bought radio.There is a wiring diagram on it and you should finish cables connection according to it step by step.
I advice you to check your connection again to ensure that all wires are plugged right.After correct
connection,you can turn on new radio first to check if your installation is right.If the machine can
works,then you can put things that are removed back to primary positions.
It’s usual for you if don’t do it exactly like this,after all it’s not right procedure.Actually the
difference is mainly on removal,and general removal operations including:prize trim panels
with a pry tool,remove screws which is used to firm car stereo and disconnect cables that
Remember to be patient and careful to do this work,it’s not hard to achieve and wish you