There is a common phenomenon that more and more car owners are capable of install a new car stereo on their own. It sounds very attractive, isn’t it? Do you want to be one of them? Perhaps you think it too hard for you to succeed, but as a matter of fact, to upgrade a factory stereo with a new car stereo can be also possible for you if you are given a correct installation guide. Look at the picture below which is a Seicane 2007-2012 GMC Tahoe GPS nav car stereo after installation. You can refer to the following installation instruction if you have the same dashboard in your car.
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2007-2012 GMC Tahoe car stereo installation instruction
1.Remove panel holding access to fuses in driver side.
2.Remove two screws under steering wheel column panel.
3.Remove one bolt from the same area.
4.Remove steering wheel column panel by pulling back to release clips.
5. Use a plastic knife to release clips by pulling panel outwards.
6.Remove bolts holding in ac controls.
7. Pull out the AC controls.
8.Remove bolts holding in factory stereo.
9.Remove factory stereo and unplug connectors.
10. Check all the accessories for the new Seicane car stereo.
11. Connect the harnesses to the back of the new Seicane car stereo.
12. Connect the Seicane car stereo to your original stereo’s plugs.
13. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
14. Put the new Seicane car stereo into the dash.
15. Put everything into their original place. All the installation is done.
With such an easy installation guide for a 2007-2012 GMC Tahoe GPS nav car stereo, can you finish the whole installation process now? If you have any question, you can seek help from your dealer or someone experienced for valuable advice. Or you can ask a professional for help. However, before the installation, please confirm that you have a compatible car stereo for your car. If your new car stereo cannot fit well with your car, you’d better quit it and but another one. Here I’d like to share a remarkable 2007-2012 GMC Tahoe GPS nav car stereo with GPS from Seicane with you. You can check out the link below for details. Wish you like it.
After installation, the steering wheel can still remains its original functions. This unit, equipped with built-in Bluetooth module, allows you to get access to hands-free call for safety and streaming music for enjoyment by wirelessly sync with your mobile phone with it keep hands on the steering wheel. With the help of GPS positioning in high precision, you are able to reach your ideal destination correctly. Besides, the additional entertainment features can also bring you a lot of joyfulness. If you like it, don’t forget to add it to your cart. Good luck to you!